AllMotion: Stepper Starter Kits EZHR23SK

使你的电机在半小时内即可运行！

EZHR23SK入门套件结合了一个EZHR23（3安培40V）步进电机控制器+驱动器，RS485转换器，以及首次使用者所需的所有电缆，使其步进电机在不到半小时内运行。用户只需提供电源，步进电机和PC。

套件中包含的EZHR23步进电机控制器预编程了一个短的移动序列，使电机在每个方向上运行200步。一旦通电，就会发生这种情况。最初不需要连接到PC。只需连接步进电机，接通电源，电机就会旋转。 （步进驱动器中的此加电序列可以在以后擦除或替换为其他序列）。

EZStepper接线图的第二页显示了如何连接EZHR23步进电机控制器+驱动器。

连接电机后，将RS-485转换器连接到PC上的COM端口，即可开始运行电机。请参阅网站上提供的EZ入门文档。

套件包括：

• 一个EZHR23步进电机控制器+驱动板

• 一个RS485转换器

• 一个预接线光电断路器，用作home标志

• 所有电缆

请从AllMotion网站下载最新的文档和软件

Everything to get your Motor running within half an hour!

The EZHR23SK Starter Kit combines one EZHR23 (3 Amp 40V) Stepper Motor Controller + Driver, an RS485 Converter, and all cables required for the first time user to get their Stepper Motor moving in less than half an hour. The user needs to provide only a power supply, stepper motor, and a PC.

The EZHR23 Stepper Motor Controller included with the Kit is preprogrammed with a short move sequence that will run the motor 200 steps in each direction 2 times. This happens as soon as power is applied. Initially no connection to a PC is required. Just connect your Stepper Motor, apply power and your motor will spin. (This power up sequence in the Stepper Drive can be erased or replaced with another sequence at a later time).

The second page of the EZStepper Wiring Diagram shows exactly how to wire the EZHR23 Stepper Motor Controller + Drive.

Once your motor is connected, connect the RS-485 Converter to your COM port on a PC and you'll be ready to start moving your motor. Please refer to the EZStart Document available on the website.

Kit Includes:

资料下载